so i have a 2001 integra gsr with original head and b18b bottom end... lately i been getting map engine code 3...( light flash three times when i jump the connector ) im sure this is a MAP sensor code.... now my wiring harness is clean and so is my intake system.... so for ***** and giggles i swapped out my MAP sensors with one in perfect working order...all was well until a 7 miles down the road, there was again loss of power, bogging, and my check engine light.... anyways i can always clear it up, by turning off my car, then putting the key in the run position and pop 4th gear, and it erases the light and code...


my thought... maybe the small rubber o-ring between the MAP sensor and the TB has gone bad..?? i don't know but i would like some input please HT!

 

[yo... anyone>??