Cam timing.
Thread Starter
Joined: Feb 2003
Posts: 59
Likes: 0
From: colorado springs, co, 80919
Skunk Stage twoCam timing
okay so I just installed skunk two cams into a b16. for optimum power the instructions say to set the cams to the following specs:
intake:
opening @ 1 mm: 37 deg. BTDC
Closing @ 1 mm: 49 deg. ABDC
Exhaust:
Opening @ 1mm: 61 deg. BBDC
Closing @ 1mm: 21 deg ATDC
I dont have a 360 deg table to bolt to the cams so I can see where they are. I do have adjustable cam gears. Does anyone know a good setting for these with cam gears while keeping the valve to piston clearance good?
thanks ahead of time any thing will help.
Paul
[Modified by simplestyles, 11:28 PM 3/9/2003]
intake:
opening @ 1 mm: 37 deg. BTDC
Closing @ 1 mm: 49 deg. ABDC
Exhaust:
Opening @ 1mm: 61 deg. BBDC
Closing @ 1mm: 21 deg ATDC
I dont have a 360 deg table to bolt to the cams so I can see where they are. I do have adjustable cam gears. Does anyone know a good setting for these with cam gears while keeping the valve to piston clearance good?
thanks ahead of time any thing will help.
Paul
[Modified by simplestyles, 11:28 PM 3/9/2003]
Darth ModerVader
Joined: Jan 2001
Posts: 11,539
Likes: 1
From: Mustafar
Re: Skunk Stage twoCam timing (simplestyles)
someone any one. I have them set but not much difference. I need the best setting if someone knows
Thread
Thread Starter
Forum
Replies
Last Post