does anybody no if i can put in the main bearings with out pulling the motor? any help would be nice. O its a 1990 crx si

 

yea, you can loosen up all the caps (sometime you have to remove them) and slide them in, except the end one by the tranny wont go in tho. just loosen use a screw driver and push the bearing around the crank and replace it the same way. The last time i did it, i had to pull the oil pump off so i could pull down on the crank to get enough space to slide it in.

 

yeh u can do a bearing roll...i wouldnt recommend it, i would pull the motor and check all ur clearances first if they are out of spec ur just going to get back in the same problem....they do sell oversized bearings im some cases, so thats the way i would go...

 

jeeez talk about half assing it!!

 

the way i see it.. its a 90 crx im guessing close to 200k miles. do you really wanna go through all the work to replace a main bearing..