Anyone interested in VERY cheap porting work?
Thread Starter
New User
Joined: Jun 2001
Posts: 8
Likes: 0
From: Evansville, IN, USA
Anyone interested in VERY cheap porting work?
I can do port and polish work for VERY cheap. Usually around 20-25 bucks per port. Plus I've learned from a teacher at WyoTech who's been doing this for about 10 years or so. I also know a few tricks, some of which should cause a tornado effect in the cylinder and a very good swirl inside the combustion chamber, thereby at least promoting better fuel economy, if not a good jump in power. Let me know if you're interested.
Thread
Thread Starter
Forum
Replies
Last Post
