Hey do u guys think this is even worth it for now? I want soem more power but i dont want to go custom piston yet or rip the head off to mill it.. I did get the P8R head with my B20 so Its got 33mmintake valves stock so Im thinking I might see some gains top end. later on I might resleeve my Ls block and throw it in and make an all motor monster. help is appreciated, and if anyone has doen this with a stock Low CR B20b Let me know! thx.

 

<---------would like to know too.

 

Well.. TTT then anyone done this?

 

bump

 

ttt

 

I am going to be running 404s on a B20B (but milled .03")

I wouldn't run it with out milling, you will be losing cranking pressure like mad.

 

hmm what happens when u lose cranking pressure?

 

seems like those 404's need higher compression.

 

404 def need higher compression like 11:1 maybe higher not sure what throwing them in a low cr motor will do but i doubt too much

 

I'm currently running those cam's in an allmotor b20b setup I have going. The head is fully p@p and portmatched both I@E. I also milled 35 thousands off to. the motor pulls hard and runs well. My comp. is about 9.6, that's a rough estimate.
Now that I've tasted that I want more. I HATE THIS ****** HOBBY!!!!

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by ****-vtec &raquo;</TD></TR><TR><TD CLASS="quote">My comp. is about 9.6, that's a rough estimate.</TD></TR></TABLE>
i got 9.4, just for future knowledge