Okay, here is the setup I have planned. I'm just wondering what compression pistons I should to with to get around 9.3 cr. B18b1 non-vtec head.

Benson Sleeves 84mm
Benson balanced/micropolished crank
CP Pistons & Rings 84mm
Eagle Rods
ACL Bearings

Port Flow Port & Polish, 3 angle valve job
Ferrea .5mm oversized valves
Rocket Motorsports L21 cams
Rocket Motorsports springs & retainers

I was also wondering how much power you all think I will get out of this with a gt35e at around 22-23psi?

All Suggestions welcome.


Modified by TrumpTiteJoker at 4:33 AM 5/6/2004

 

just get pistons for your motor, and size, and they will tell you what CR they will yeild. Or you can call them directly...

 

When I get the headwork done, the compression ratio will go down wont it? So if I'm going for a 9.3cr or somewhere close, I will have to get like, 9.5cr pistons? Any help is appreciated.

 

if your going to be running this as a daily driver, just get the 9.0:1 C/R it will work just fine. In the long run, you can just turn up the boost a little bit more. Especially when your going to run 22+psi