just wanted to see the inlinepro t3 manifold from the bottom side

 

up

 

I have no idea what you would want to search under but I remember seeing a picture of one on here that Full-Race Geoff (If I remember right) had ground out to match a turbo. You also might try Arturbo. I am sure he has a picture of one.

-Ryan

EDIT-Found one. Thanks Art!

 

thanks.that is exactly what i was after

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by Kwuaymaikrup &raquo;</TD></TR><TR><TD CLASS="quote"> </TD></TR></TABLE>

A little OT, but is that the ideal place to tap that mani for EGT?? Just wanted to know for future reference.

 

Ideally, number 3 runner is the best becuase historically, number 3's EGT are usually higher than the rest. So if number 3 is runng cool, you are in the clear. Unless of course you are trying to get more of a combined temp. But getting your signall from number 3 is the best bet IMO.


Rob

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by rjardy &raquo;</TD></TR><TR><TD CLASS="quote">Ideally, number 3 runner is the best becuase historically, number 3's EGT are usually higher than the rest. So if number 3 is runng cool, you are in the clear. Unless of course you are trying to get more of a combined temp. But getting your signall from number 3 is the best bet IMO.


Rob</TD></TR></TABLE>

I knew that, but I was asking about the inline pro. I have never seen an EGT on that mani before. Thank you for your input though. Ill stop jacking this thread now.

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by TeStUdO &raquo;</TD></TR><TR><TD CLASS="quote">

A little OT, but is that the ideal place to tap that mani for EGT?? Just wanted to know for future reference.</TD></TR></TABLE>

ideal place is on the #3 cylinder, distance from the head should be 1/2 the diameter of the runner.

 

The Inlinepro manifold is quite thick, I broke 2 bits trying to drill it

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by BG Boost &raquo;</TD></TR><TR><TD CLASS="quote">The Inlinepro manifold is quite thick, I broke 2 bits trying to drill it </TD></TR></TABLE>

Thast because its Stainless Steal too.....

 

Yeah I busted a few bits trying to drill mine as well.


Rob

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by turbotypeR &raquo;</TD></TR><TR><TD CLASS="quote">thanks.that is exactly what i was after </TD></TR></TABLE>

No prob!