i'm adding an msd kit on my car. when you remove the stock coil, there are two wires that connect to the stock coil. one is grey and yellow and the other is yellow and blue, i may have got the colors wrong. where do i put those wires when i take them off the stock coil? i didn't put them anywhere at first and when i tried to turn on my car, it wouldn't start.

can somebody explain to me how to do this or let me know of any good websites with instructions.

TIA

 

http://www.msdignition.com/pdf/pdf24.pdf

is this correct?

 

anyone know who has installed an msd sci????

 

Which msd ignition parts are you using?, 8207 and Digital SCI plus ? If so, the blk/yellow and white/blu wires inside the distributor will run to the msd ignition box, blk/yellow goes to red, and the white/blu goes to the white. And then the Black and orange wires from the msd unit will go the the new coil, Orange to positive and black to negative, hope this helps?

 

msd sci, msd cap 8292, msd blaster 3 coil

i figured it goes like this:

thick red to battery
thick black to battery

orange to blaster 3 coil
black to blaster 3 coil

thin red to one of the wires that disconnects from the stock coil
white to the other wire that disconnects from the stock coil

is that right?

 

YOU GOT IT !