gsr vs. ls turbo
If everything is setup correctly with properly sized turbos for the different motors the GSR motor should make more power and therefore win assuming the power can get to the ground. the VTEC head simply can flow more air then an LS head. However, if cost is a concern, for the price of a GSR motor swap I believe you could make an LS faster.
I had friends boost up to 12psi at the track with a bone stock GSR. I don't know about LS motors though.
One friend hit a 12.8 with a bone stock GSR @ 8psi. With 22x13 inch slicks of course.
One friend hit a 12.8 with a bone stock GSR @ 8psi. With 22x13 inch slicks of course.
Trending Topics
well the GSR does have a higher compression that the LS. I have boosted up to 10 psi on my LS CRX, with stock injectors and 112 leaded racing gas. But back in 99 I did see a guy and his friend both with the same setup. 96 Integra LS, both were running 550cc injectors with DFI and tuned by JG(YUCK), and also were running stock bottom end. They would hit consistent low 12's. 12.5, 12.3 12.0. And they were running 15psi. I don't think the GSR stock bottom end more can handle it just due to the fact that it has a higher compression that the LS motor. I could be wrong. LS motor parts are easier to find that GSR.. Just my 2 pennies. PEace out
If both are done the same leavin the gsr stock high 10:1 CR then i'd definitely would gone with the LS. But if the gsr was done up the bottom end definitely the gsr would win. Hey accordking your friend gsr still runin fine on that stock bottom end @ 8psi?? What kind of turbo kit was it? Thanks.
[Modified by IgniteTeg, 4:44 AM 8/11/2001]
[Modified by IgniteTeg, 4:44 AM 8/11/2001]
The car with the GS-R will win. Also depends on the driver. There is this guy that ran 20 psi on a GS-R and only hit a flat 13. Lack of track experience.
You can build an LS engine to be really beasty. Just need the $$. There is a guy that ran a 11.9 with slicks @ 14 psi on a built engine. 92 integra i believe. Full interior.
You can build an LS engine to be really beasty. Just need the $$. There is a guy that ran a 11.9 with slicks @ 14 psi on a built engine. 92 integra i believe. Full interior.
He bought a used first generation DRAG kit with a chipped compressor blade. He's running fine at the track with 8psi. But for everyday use he's only boosting 6psi.
Thread
Thread Starter
Forum
Replies
Last Post




