I just put a set of stainless lines on my R and bled the brakes and now the ABS light is on. Anyone else have this problem???

 

Short the SCS connector and see what ABS code you are getting.

 

it was flashing code 11 and 13

 

I can check the manual tomorrow at work and tell you what circuits/components to look at.

 

I have the service manual right here. I already looked the codes up and found out what they were, I just don't really want to go through all that troubleshooting **** unless I absolutely have to. I just wanted to see If anyone had the same problem or something similar that could help. Thanks for the offer.

 

Reset the ECU and see if it comes back on.

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by Yellow00TypeR &raquo;</TD></TR><TR><TD CLASS="quote">it was flashing code 11 and 13</TD></TR></TABLE>
You may have broken the wires for your wheel speed sensors.
Code #11- r/f wheel speed sensor.
Code #13 l/f wheel speed sensor.
The wire will appear intact, but inside it's broken.
Unless you unplugged the sensors and forgot to plug them in.