need help with tach!!!
Thread Starter
Honda-Tech Member
Joined: Jul 2002
Posts: 1,249
Likes: 0
From: Cville, VA, USA
need help with tach!!!
i'm installing an aftermarket tach for this guy and i can't figure out where the signal wire goes. everything else is wired up, but when you rev the engine, the tach doesn't repsond like it should.
where does the signal wire go to make the tach read the engine speed?
where does the signal wire go to make the tach read the engine speed?
Joined: Sep 2002
Posts: 3,416
Likes: 0
From: Columbus, GA, USA
On the harnesss to the right of the master cylinder.
Look for a blue wire. You must splice into that. Also be sure that the Tach (if autometer) is cut for 4 cylinder otherwise it'll read 1/2 of the RPMs.
Look for a blue wire. You must splice into that. Also be sure that the Tach (if autometer) is cut for 4 cylinder otherwise it'll read 1/2 of the RPMs.
Thread
Thread Starter
Forum
Replies
Last Post
A.D.D. Racer
Honda Civic / Del Sol (1992 - 2000)
2
May 24, 2006 09:02 AM