N20 on mildly built GSR
Thread Starter
Honda-Tech Member
Joined: Sep 2002
Posts: 1,141
Likes: 0
From: Raleigh, United States
I have searched for a while and i was wondering how much of a nitrous shot a gsr with JE 10:1 pistons, Eagle Rods, SKunk two cams and valvetrain could take. My bud is hoping for a 100 shot. Will he need a n20 controller?
i need more info what stage skunk2 u using....because this matters....alot...and are u on a stock clutch or an aftermarket one....? this would help everyone on this board a whole lot...
but your bottom end is pretty built so i figure you could be shootin at least 100 shot if your engine is well maintain...valve springs and retainer....are good too...
but hopefully you don't have skunk2 stage 2 or 3 i heard its too much over lap and not good with runnin nitrous...but stage 1 will be fine...an aftermarket clutch will help you put all this hp to the ground too.
but your bottom end is pretty built so i figure you could be shootin at least 100 shot if your engine is well maintain...valve springs and retainer....are good too...
but hopefully you don't have skunk2 stage 2 or 3 i heard its too much over lap and not good with runnin nitrous...but stage 1 will be fine...an aftermarket clutch will help you put all this hp to the ground too.
Thread
Thread Starter
Forum
Replies
Last Post




