I need a longer fuel line that goes from the fuel filter to the fuel rail

what ends will I need?

the guys here recomended these. but what size should i go with?




and use the teflon hose

http://www.racerpartswholesale.com/aero3.htm

i was going to re-use the factory ends brass ends and attach the hose the the brass ends

i figure this will cost me something in the 30 dollar range. i could just an itr fuel line, it will cost 55 from the dealer with my discount

btw, this is for a 95 gsr with skunk2 intake manifold. my intake piping will not fit with my stock fuel line


[Modified by Bob-DC2, 9:38 AM 11/21/2002]

 

ok are you going into your stock fuel rail or aftermrket?

 

you'll need 12x1.5mm to -6AN adapter, both males
then a -6 lines with both hose ends,
then a -6an to an O-ring boss thread fitting to your fuel rail...unless you;re running stock fuel rail....

 

stock fuel rail

do i just hack off the banjo fittings on the fuel line?

 

No, you take the stock line off and throw it away.

Stan, I thought the fittings needed were 12x1.25 not 12x1.5?