B16A 1st Gen with a 2nd Gen EG9 loom
Thread Starter
Trial User
Joined: Nov 2019
Posts: 1
Likes: 0
B16A 1st Gen with a 2nd Gen EG9 loom
Hello all,
I have just obtained an unfinished project, an EG8 with a 1st Gen b16a engine (PGM-Fi type manifold). I have a full EG9 loom and after doing some research I think all I need to fit the EG9 loom to the 1st gen engine is a different intake manifold, throttle body and distributor. Can anyone confirm this and/or give me more information as to what I need to do to make this work.
Thanks in advance
I have just obtained an unfinished project, an EG8 with a 1st Gen b16a engine (PGM-Fi type manifold). I have a full EG9 loom and after doing some research I think all I need to fit the EG9 loom to the 1st gen engine is a different intake manifold, throttle body and distributor. Can anyone confirm this and/or give me more information as to what I need to do to make this work.
Thanks in advance
Thread
Thread Starter
Forum
Replies
Last Post
all-mtr-teg
All Motor / Naturally Aspirated
5
Jun 20, 2008 10:50 AM