Hi, I’ve Installed A New Flywheel, Clutch, Pressure Plate, Throwout Bearing, All Done Correctly, Installed A New Slave &’ Master Cylinder,Bleed The System, &’ Still No Pressure On Clutch Pedal, I Can Start The Car With The Clutch Pedal Pessed To The Floor, But It Won’t Let Me Go Into Any Gears While Car Is On.. Please Help

 

You may have a bent selector fork. Did you bench test the transmission before installation?

 

too much free play may not allow enough movement to disengage the clutch

 

Yes I Bench tested to make sure everything was properly operational, I’m Hoping There’s Just A Lot Of Air In The System &’ Nothing Serious