Hey guys. I have searched for how to install the catch can but what i mostly got was which system is better and what not. So my question is, is this how you basically install this catch can. The catch can has 3 ports. 2 on the side and 1 on the bottom. The 2 on the side run to the VC and the 1 on the bottom goes to the black box? Is there anything else I have to delete?

GO-AUTOWORKS Catchcan Kits

here is what is included :

B Series VC/Drain kit:

1 Aluminum S Can w/ 2 -10AN Inlet fittings, 1 -10AN drainback fitting and filter

3 90 degree -10AN fittings

3 -10 AN Straight fittings

1 10AN rear block conversion drainback fitting

9 ft -10AN hose

 

You remove the black box and run the drain back port in the block where the black box was mounted, the other 2 are from the vc. If it was me I'd just skip the drain back part and only run the 2 vc ports. You can end up with water in your oil running the drain back system.

 

Thanks and what do I do about those 2 lines that go from the black box to the motor. If i take out the box isnt that hole going to be uncovered?

 

Should I just take those 2 lines leave the hose connected and put a screw in the hose?

 

Depends on which can you use, with the go auto kit

2 bungs get welded to the valve cover, you remove the black box and install the drain fitting included in the kit. The other 2 hoses that originally went to black box get capped off with vacuum line plugs.

running a drain back is debatable. B and R fittings sells catch cans in different styles. I went with a non drainback system, removed the black box and plugged the hole with a freeze plug