Ok this motor was in my hatch for about a yr, was in m friends car for few yrs. unkown miles. Had wp/tb/ headgasket done within last yr.

Story on what happen:

Went to lunch break, wen in got food started up heard small "knock". Drove 1 mile back to shop i work at. Worked rest of day had towed home. Did alittle diag to it. It would knock as soon as you start and went away in less than 1/2 sec. Rev as high as you care no knock at all. Sat for about a month swaped out. Finally got around to looking at it last week. It appears as if #3/4 rod bearings spun around big end of rod. CRANK IS NOT HURT. Big end of rod caps are not hurt either, locating spot on rod cap for rod bearing is intact not hurt either. The motor still ran very good the day i took out (other than knock at start up). A few ppl can vouch for the motor and things i have stated.

It is a 100% complete from V/C- oil pan. Yes comes with dizzy. Will come w/ gsr fuel rail and obd2 inj (i had custom fuel setup).

$170 firm picked up in daytona

 

$130 come get it, need gone

 

no tranny ? 954 821 8051 hmu if u have a tranny

 

No trans.