Ok, I had a question about my brace.

I just recent got one and put it on my EG Hatch.

Fitment was pretty tight. Upon removal of the original lca bolts at the stock subframe, one of the backings with the nut welded to it fell off.

So I just put a washer/nut on the back of that Subframe LCA Bolt.


Now my question, I was looking through the wheel well the other day and my brace looks bowed out?

If you look at it from the back, it looks fine, but removing a wheel and looking at it from the side, you can clearly tell its bowed.

I didnt think it should be bowed, hence this thread.


If anyone needs pics, LMK.

Any insight? I have searched but apparently I am the only one or I suck at choosing keywords..

Thanks.

 

Question: Did you contact F7? Email them your pics?

 

Their website has no way to contact them?

http://www.function-7.com/home

*Edit*

Just found their number on this page?

http://www.function-7.com/distributors

 

info@function7.com
(480)818-5258
I've never heard of anyone that had an issue like yours. Maybe it was never noticed?

 

For that High dollar sub-brace art, I'd definitely give them a call with follow-up email photos. Just from the hip though, their products are supposed to be made of 7075T-6 which, unlike 6061T-6, is very ridged and not prone at all to warping or load distorting - being more brittle than ductile, it would probably break first. Did you get it from them or one of their authorized retailers?

 

function7 was real quick about getting back to me about some small issues i had with their brace and lca's for my rsx. good company to deal with.

 

It was purchased from JHPUSA.

I will be calling them in the AM and sending a followup email too

 

F7 customer service is excellent. you can also PM them on here. It may take a bit to hear back because of the holidays, but who knows.

Can you post pictures of what you are seeing?

 

Ill snap some pictures for you guys tomorrow. Its a little dark here.

 

Did you get any resolve of the distortion issue? I remember back in the day, when I was researching LCA's for purchase on my EG and EJ projects, I liked theirs as being hands-down the coolest looking, but I concluded I would be more inclined to use them on a 1/4 mile racer application as-opposed-to a street racer. I ended-up buying the only LCA's that were made of 2024T-3 at the time.

At any rate, I hope that you got it resolved.