Hey guys,

-I'm planning on overlaying an open in my CKP sensor wiring circuit from the 8-pin plug off my OBD1 distributor straight to the ECU which should be B15.(its the BLU/GRN wire)

-The problem is that its a braided wire.(with the BLU/YLW wire)

-Could i just run a new wire straight from the 8-pin connector to my ECU?

-OR will i have to overlay both wires from the CKP sensor(the BLU/YLW and the BLU/GRN wire) and twist them together?

-OR does the term "braided wire" mean something else?

any suggestions would be great.

AND THANKS IN ADVANCE

 

Any wiring gurus feel free to chime in

 

Nevermind guys but thanks anyways. I was able to get a hold of Peter @
Rywire.

Thanks again