I just got done converting my p06 to vtec and now the car barley runs and won't idle. It's a 11F0 board and a xenocron vtec conversion kit. Any advice or help is much appreciated. Thanks.

 

Check your solder joints. Most likely you didn't do a good job.

 

I hope you don't take this the wrong way, but you socketed and chipped the ECU at the same time right? You didn't just add the VTEC components to a stock ECU correct? Also, any check engine light codes?

 

The ecu was already socketed and chipped. I had a f22b2(non vtec) in the car and it was tuned and ran great. Blew it up and put a f22b1(vtec) in and just put the vtec conversion kit in, now it runs like crap. No CEL's.

 

Did you put a new basemap on it? Post a picture of both sides of your ecu.