Hi guys , please can you help me for safe sample ignition table .... for AEM EMS on 93 pump gas

Semi build setup ...
pt6765 billet .63
9.0:1 CP forget pistons and eagle rods
fully build b16 head with valves , valvetrains and retainers Supertech
bosch 044 fuel pump and 1000cc FIC injectors

 

Just pull 1 degree per pound of boost for now. Then put it on a dyno and fine tune it.

 

Will be intrested to see where this setup starts to build boost, I want to use a 6765 with my b16.

 

Very very late. Huge turbo for a b16

 

It will spool just fine. The 6765 is a great turbo. I have one on an lsvtec and it's not laggy

 

I looked at the picture, only thing I noticed was your jacket says "Escort Service"

 

Way too big of a turbo on a b16....

1 degree per pound of boost for street tuning, see how the car likes it, from there i'd go with .75 depending on how the plugs come out, you dont necessarly need a dyno to tune the ign, just read the plugs properly...

 

your LS/V will obviously spool a turbo a good bit faster than a B16... there is a pretty considerable stroke difference going on there.

 

Yes I understand^ but I had a b16 with a 62-1 And when i went lsvtec i originally used the same turbo setup And only saw 400rpm difference in spool.

 

Everyone loves a bit of escort service