Im having some trouble figuring out how to do my dumptube on my Crx with a gsr using the inlinepro cast mani and now my dump goes right infront of the intake on the turbo and im sure that will kill power with heat and restriction on the intake of the turbo, any ideas on how to re-run the dump so i wont have any problems like this? Here is a picture of how it sits now, not really alot of room to move it around

 

I would extend it and route it through the side of the front bumper. If that's too conspicuous for you, extend and route it to dump under your engine.

I would cover that turbo intlet with a mesh screen ATLEAST or filter if i were you..

 

Use a 90* elbow between manifold and wastegate that points it towards (has it sitting over) the exhaust side. That's what I would do.

 

Id put a short 45* on it angled under the oil pan.

 

Im either going to do out the bumper or the 90 so its on the hotside.. Depends on how much it will cost to do either.. Going to a local shop friday to get it redone