I have a stock motor S2k with a 6262, AEM, etc. I am running on ID1600s (thanks Tony1) and am currently on 1 Walbro. I am looking to add a 2nd Walbro, and I have experience with this. (sc300 with 3 Walbros and -10 lines)

My question is, how much can my stock hardlines flow? (AP1) I am looking to make around 500-550rwhp on E85, and Tony will be tuning it, so I know that is easily done. I just need to know if I need to change out my lines, or if around 550 can be done on the stock lines, with 2 pumps and ID1600s. Thanks

Quincy

 

And here's a pic of it. It's really the only one I have. The car stays at the shop. Shout out to Vik-tek. www.viktekperformance.com



Quincy

 

i remember 550 was nearing the limits for the stock lines but was still safe (if i remember right). I think the stock lines hold over 600whp, but if you're going dual-walbros and want more power in the future it's not a bad idea to do it now

 

What power level are you at? What fuel system? If you don't mind me asking.

Quincy

 

I was just about to make a thread for the same question! Look at a bosch inline pump with a 255. I dont know about the fuel lines. Have you asked Tony what he would use?

 

No, I haven't talked to Tony yet. I figured someone on here would know. Tony is a busy guy.lol But I may just have to give him a call.

Quincy

 

look in the FI section on S2ki. thats where I got the reference from.

For me personally I'm only shooting for 500whp on stock lines.