i started today and took out the wiring harness and took off the head so it would be easier to reach things.

i didnt have a strong enough impact for the axle nut so i had to take the whole rotor and shaft assembly out, man that took some time.


hopefully tomorow i will pull the block.

[Modified by baonest, 7:10 PM 9/24/2002]


[Modified by baonest, 7:11 PM 9/24/2002]

 

Good old Hard Labor!!!

 

What is it you're trying to do here?

 

Yeah, what are you doing? Not pulling the motor are you?

 

Dropping in a 350?


[Modified by Tommy_Gunns, 6:57 PM 9/24/2002]

 

takin the motor out... then puttin in my LS/vtec when im dont with it. i took the AC out.. the car was a theft recovery so ima be cleanin the engine bay and the inside..

 

ah..doin' it the long and hard way

 

yea really, i was pissed when i couldnt take the axle bolt off cuz i already drained the break lines and the car was up on jack stands. it really sucked. but its ready for tomorows pull, then its gonna sit for a while until i get my tranny from brian (b18c1_powered_si who is a reall good guy). the JUN head kits is gonna take a about a month to get here cuz it needs to be ordered from japan (ITRinEJ1 is takin care of that ). now i need flywheel/clutch combo from somone.. hmmmm


[Modified by baonest, 12:40 AM 9/25/2002]