Look whats been left at my door the past week:

 

nice wat kind is that mnaifold? how much?

 

what's in the box?
what's in the box?

what DPR stage did you get?

 

whats the manifold?

 

that mani kinda reminds me of an SFP mani..but i dont think it is

 

Yes that is an SFP race manifold for B seies. This is whats in the box:

 

VERY VERY nice, who did the head looks really good man!


Rob

 

methinks it was Dan Paramore

 

It's DPR stage V headwork. Vey nice service I must add.

 

drool

 

I wish I had a real job so I could afford!!!!

 

very very nice, once again!

Rob

 

how much is the head?

 

**** tha UPS man...... Viren (b18bturbo) sent out my block, rods, pistons, VAFC, and oil pump gear last tuesday, and UPS didn't put it on a truck to come from TX to NC until like Friday......... so now i've got no wheels for NOPI, i'l just have to drive the old LS/VTEC race car i guess.....

 

Labor & parts on the head were about $1000.

 

It's simply amazing the money these places are charging (and people are actually paying) for on these heads. I mean, that's ONE HEAD.

Has anybody ever seen an independent dyno comparison between DPR or Portflow and a stock head? I'd be very interested to see the results.

 

me too. They're both about the same prices so it would be a good shootout. So many variables though. It'd be kinda tough.

s

 

Take 3 fresh motors and do it, let some stupid magazine like SSC or SS pay for it.


What are the parts and labor involved?

 

Stage V Headwork $900:

Competition Port & Polish Deshrouded & Polished Combustion Chambers
Back-Cut Valves
Radiused Blend Seats
Three-Angle Valve Job
Hand-lapped & Vacuum-Tested Valve Seats
Cylinder Head Deburred & Blueprinted
Combustion Chambers C.C.'d
Detailed Matched Intake Manifold Fully Ported to Head
and Throttle Body
Match Port Exhaust Manifolds
Port Faces Lapped Flat (Studs removed and reinstalled)
Decks Milled & Lapped (At any amount with no additional charge)
Radiused Cut Seats

About $100 for 16 valve guides