I was wondering if I can hone just this cylinder wall myself? It has a minor nick and scratch on cylinder wall. Apparently its just one cylinder wall. So I wanted to know if I can do it myself or not. Or to be on the safe side bring it to the machine shop? The bottom edge seems to be not in perfect round shape. Will that affect anything? Any suggestions? Also The oil jet seems to be crooked and is rubbing against the crank. Here are some pictures.







the block itself already been bore .20 over. So just by judging by the picture. Does it seem ok if I can get away with just a hone. Or do i need to get it bore some more as well?

 

take it to the machine shop to c what they have to say

 

cuz it looks like u can hone it urself but to be on the safe side

 

is it just me or does the OilJet look out of place? It looks a bit off? correct me if im wrong?

 

it does look out of place

 

any other suggestion?

 

i guess the machinist said that the nick was too low for the rings to catch it. But I worry it might scar the piston. Any suggestion for that?