Cylinder Wall has minor nick and scratch. Can I do honing myself? pix*
#1
Honda-Tech Member
Thread Starter
Join Date: Jun 2005
Posts: 1,037
Likes: 0
Received 0 Likes
on
0 Posts
Cylinder Wall has minor nick and scratch. Can I do honing myself? pix*
I was wondering if I can hone just this cylinder wall myself? It has a minor nick and scratch on cylinder wall. Apparently its just one cylinder wall. So I wanted to know if I can do it myself or not. Or to be on the safe side bring it to the machine shop? The bottom edge seems to be not in perfect round shape. Will that affect anything? Any suggestions? Also The oil jet seems to be crooked and is rubbing against the crank. Here are some pictures.
the block itself already been bore .20 over. So just by judging by the picture. Does it seem ok if I can get away with just a hone. Or do i need to get it bore some more as well?
the block itself already been bore .20 over. So just by judging by the picture. Does it seem ok if I can get away with just a hone. Or do i need to get it bore some more as well?
#4
Honda-Tech Member
Thread Starter
Join Date: Jun 2005
Posts: 1,037
Likes: 0
Received 0 Likes
on
0 Posts
Re: Cylinder Wall has minor nick and scratch. Can I do honing myself? pix*
is it just me or does the OilJet look out of place? It looks a bit off? correct me if im wrong?
#7
Honda-Tech Member
Thread Starter
Join Date: Jun 2005
Posts: 1,037
Likes: 0
Received 0 Likes
on
0 Posts
Re: Cylinder Wall has minor nick and scratch. Can I do honing myself? pix*
i guess the machinist said that the nick was too low for the rings to catch it. But I worry it might scar the piston. Any suggestion for that?
Thread
Thread Starter
Forum
Replies
Last Post
bb_one
Tech / Misc
11
04-14-2005 04:38 AM