Here is my setup. My question is would stepping up to a pro1 camshaft hurt me with nitrous ? I am looking at a direct port kit going to spray a 100 shot.

Also I am running a single layer headgasket right now, is it safe to spray with this setup or should I be concerned ?



H22a
BPI velocity Stack
AEM 3 inch intake
68mm AEBS TB
Accord Euro R manifold plenum portmatched to TB and runners ported
PP head
3 angle valve job on intake and radius on exhaust
Skunk2 Stage 1 Cams
Supertech Flat faced valves
Supertech valve springs
Supertech titanium retainers
Single Layer Headgasket
KaizenSpeed BalanceShaft Eliminator kit
Lightweight Flywheel
UR ultra R crank pulley
Camp1320 header (open)

The car was tuned by Jeff Evans.

The issue I have with running a 3 layer HG is that it will drop CR from 11.4:1 to 10.93:1.
Does anyone have experience with this or possibly with a cometic with spray ?

 

IMO you should call Jeff and ask him. There are only a few people that would try and challenge what he recommends.

 

Sounds good. Ill try it.