I am wiring up a gm 3 bar map sensor. I cut the the plug off the old sensor clip and the wires aren't the same colors as the what is in the link below. I thought maybe i cut the wrong clip off but i don't see any other of the same clips with the correct color wires. I looked at the Hondata site and i have the same color wires as an rsx.

I have a:
Green and white
red and green
yellow and red


https://honda-tech.com/forums/forced-induction-16/some-information-about-gm-3bar-connnector-install-hondata-1440585/

GND (A) connects to Green/White on factory harness
MAP signal (B) connects to White on factory harness
5V (C) connects to Yellow/Red on factory harness

 

Ok, so whats the problem? The hondata site is what I always use.

 

I dont have a white wire on the harness

 

use DVm to test

 

red goes to yellow/red. white goes to red/green. black goes to green/white.