Hey guys I just need a bit of input,

I currently have an H22A installed in my 95 DC2 Integra. I am using Hasport Mounts. I am very interested in doing the H2B conversion. Just looking for a bit of input on how much work it would be to do this swap since I have already made the adjustments for the h series swap (cutting the floor, mounts, etc). Just wondering how hard this will be in my situation. Thanks alot

 

re-weld pass mount, re-weld floor board

 

I can't use my hasport mounts with the QSD kit correct? I know I need a b series tranny mount but not sure about the rest with the QSD kit.

 

need b series mounts , not h series

94+ integra T mount for an EG
99+ SI T mount for an EK

 

so i need to sell my h series mounts and make my 22 sit on b series mounts? sorry im such a noob at this swap

 

Yeah, sell your H-series mounts, axles, and int. shaft.

Get B-series mounts, axles, and int. shaft.

<--- 4 1 6. I was born in Toronto.

 

yup. just sell your h series mounts, linkage, axles, trans. the QSD h2b kit is ALL bseries from the flywheel back. mounts, linkage, intermediate shaft, axles.. blah blah, its all b series. and like 2fastgsr said, just reweld the bracket and fill the hole in your floor board. i went from h22 to h2b(ej6 chassis) and it wasnt hard at all. i just found a donor ek for my floor board peice and i was set.

to answer your question, it is not hard

 

thanks alot guys for your input. so i just purchase the hasport b series stock replacement mount set for my dc2 correct? (plus all the other things i need)

Hows the qsd kit goin for you guys anyway?

 

yup. those are the right mounts.

I love the qsd kit. i havnt had a single problem

 

So b series axels will fit for my dc2? im not sure what you used in the Ek

 

it says ek in ur sig but u said ej6 so either or lol nice avatar by the way lmao

 

haha thanks. yea, any b series integra axles and intermediate shaft will work just fine. same goes for your shift linkage.

 

sent you a im. but thats just weird picturing a h22 sitting on b series motor mounts. i didnt think it was possible. i guess with the engine bracket or w.e they give you it is.

 

heres a pic of the driver side bracket for the h2b

 

thanks alot guys time to purcahse me a qsd kit, mounts, etc. now time to go hunting for a good header

 

might wana replace that auto tensioner. just sayin

 

can i use a chipped p28 ECU with a h22a (J-spec) basemap? or what kind of map?

 

Yes you can, thats what i used until i got my real tune done. Just be careful depending on your mods you might run a little lean. I wouldnt race on it just use it to drive normal and break everything in then get it tuned. Make sure you run 91 too jdm has 10.6 compression

 

the problem is that its hard to find anybody in germany who optimize or tune this ecu correctly because i dont know that enybody did this swap ever.