I've got a 96 Civic Hatchback with a B20z2 block and a integra GSR head. I heard if I get the civic's mid pipe and axle back that it will bolt right up to the header. Can someone confirm this? Also I'm having an idle problem. 3/4th of the time when i start the car the idle jumps from about 200 RPM to 700 RPM and sometimes its a steady idle at around 800-900 RPM. When i drive and try to punch it in either 1st or 2nd gear the car jerks like your jamming the throttle in and out. Can someone help me?

 

No one has an answer?

 

It should bolt up the pipe in about the same place. Worst you have to do is either add a section or just adjust the positioning a little.

 

d series piping is 90 degrees off, from a b series. so they wont work. you gotta get it rewelded

 

what about the idle problem i'm having?