So I decided 3 weeks ago to have a buddy paint my car. between the two of us, we disassembled and removed everyhting one would ecpect to change the color of the vehicle. Doors, hatch, interior, windows, headliner, ect... The problem came when I wanted to start the vehicle to let it run as is hasnt ran much since last summer after I dropped in a GE Sleeved block into it an boosted her. It ran fine, a bit rough because i havent had her tuned yet, but able to drive without any problems to my friends garage. When I went to start it, the motor would spin, but it wouldnt start. The motors getting fuel and spark. I thought a restriction of air, so i removed a section of charge pipe and still no start! Is there a kill switch or sensor/s that were removed within any of the pannels that are preventing the motor from starting? I have NEVER had a problem with my motor, even after the new motor was put in!!! I have NO clue why it could be doing this???