F/S 94 CIVIC COUPE SWAP|BOOSTED|CLEAN
After 7 years its time to go. I dont drive it anymore and since buying a condo, id rather put my money into that than this car. Im sad to see it go. Its a 94 civic coupe DX. This car has been garaged the entire time ive owned it. It hasnt seen a winter in 5 years or rain in the past 3. I just dont drive it anymore. All fluids changed regularly. Washed and waxed regularly. When i did drive it, i was waxing/claybaring/bodyscrubing it twice a year. The original paint is very clean for being 14 years old. The car runs strong, handles well. I built it to be well balanced in all aspects but to still look clean and simple and run reliably.
The car put down 188/171 on a dynojet running 7lbs. This was with an apexi n1 and the stock greddy downpipe. I have since put a full 3 in exhaust and 2.5in kteller downpipe on it. I have not retuned it. Included with the car will be rc310 injectors so can raise the boost and retune it. Something i was going to do but have since decided to sell it.
Here goes:
DOHC obd1 ZC
eg ex/si trans
act 12 lb flywheel
exedy organic clutch
New oem t. belt/waterpump
new oilpan and gasket
new distributer king disributer
ARP headstuds and oem headgasket
ngk plugs and wires
energy suspension mount inserts
running chrome with 2 step
short throw shifter with energy bushings
greddy turbo kit 7 lbs
turbo xs rfl bov
Mallman manual boost controler
2.25in intercooler piping
all silicone couplers and t bolt clamps
johnny race car intercooler
kteller 3in exhaust
kteller 2.5in downpipe
kteller conversion cat
aem fuel rail with gauge and fp sensor mounted
b&m fpr
fast turbo stainless line from rail to filter
new oem fuel filter
walborow 255 pump
ebay radiator
slim electric fan and new oem thermostat
golden eagle vacume block with all new vacume lines
Simple wiretuck, ctr oil cap, shaved/painted valve cover
Neuspeed/bilstien full coilovers
new rear bolts and bushings
lower rear tie bar
rear strut bar
em racing rear c pillar bar
Integra gsr front disk swap
slotted rotors and new pads/ new fluid
rotas 15x7
205/50/15 oldschool azenis. prety much like new. Under 1000 miles on them
motegi lightweight extended lug nuts
30%tint
vision corners
catz zeta headlight system
shaved front bumper
jdmshit "spoon" front lip. I will include the oem front lip as well
antena block off plate
Del sol buckets
sparco 2.5 in 4 pt harnessess
integra r oem boot and ****
armrest
jdm audio counsel
jdm cluster
coin pocket
330 mm wheel
greddy turbo timer
autometer electric fuel pressure gauge
autometer egt gauge
autometer boost gauge
all mounter in the audio counsel
Viper alarm
The drivers side seat has a very small tear on the left side. The body has some small scratches and chips from being 14 years old. There is some small honda spot rust that started forming when i bought the car. It doesnt see snow or rain, so it hasnt spread at all in the time ive owned the car.
I will include the back seat and all the stock stuff i have in the garage with the sale of the car. We can negotiate my including a carbon fiber hood in the sale.
PM FOR PRICE... The price is negotiable. BEST OFFER




I can add more picture per request
The car put down 188/171 on a dynojet running 7lbs. This was with an apexi n1 and the stock greddy downpipe. I have since put a full 3 in exhaust and 2.5in kteller downpipe on it. I have not retuned it. Included with the car will be rc310 injectors so can raise the boost and retune it. Something i was going to do but have since decided to sell it.
Here goes:
DOHC obd1 ZC
eg ex/si trans
act 12 lb flywheel
exedy organic clutch
New oem t. belt/waterpump
new oilpan and gasket
new distributer king disributer
ARP headstuds and oem headgasket
ngk plugs and wires
energy suspension mount inserts
running chrome with 2 step
short throw shifter with energy bushings
greddy turbo kit 7 lbs
turbo xs rfl bov
Mallman manual boost controler
2.25in intercooler piping
all silicone couplers and t bolt clamps
johnny race car intercooler
kteller 3in exhaust
kteller 2.5in downpipe
kteller conversion cat
aem fuel rail with gauge and fp sensor mounted
b&m fpr
fast turbo stainless line from rail to filter
new oem fuel filter
walborow 255 pump
ebay radiator
slim electric fan and new oem thermostat
golden eagle vacume block with all new vacume lines
Simple wiretuck, ctr oil cap, shaved/painted valve cover
Neuspeed/bilstien full coilovers
new rear bolts and bushings
lower rear tie bar
rear strut bar
em racing rear c pillar bar
Integra gsr front disk swap
slotted rotors and new pads/ new fluid
rotas 15x7
205/50/15 oldschool azenis. prety much like new. Under 1000 miles on them
motegi lightweight extended lug nuts
30%tint
vision corners
catz zeta headlight system
shaved front bumper
jdmshit "spoon" front lip. I will include the oem front lip as well
antena block off plate
Del sol buckets
sparco 2.5 in 4 pt harnessess
integra r oem boot and ****
armrest
jdm audio counsel
jdm cluster
coin pocket
330 mm wheel
greddy turbo timer
autometer electric fuel pressure gauge
autometer egt gauge
autometer boost gauge
all mounter in the audio counsel
Viper alarm
The drivers side seat has a very small tear on the left side. The body has some small scratches and chips from being 14 years old. There is some small honda spot rust that started forming when i bought the car. It doesnt see snow or rain, so it hasnt spread at all in the time ive owned the car.
I will include the back seat and all the stock stuff i have in the garage with the sale of the car. We can negotiate my including a carbon fiber hood in the sale.
PM FOR PRICE... The price is negotiable. BEST OFFER




I can add more picture per request
Trending Topics
I couldnt tell you what brand it is. I bought the hood back in 02 when my buddy worked at hard tuned cars. Its an old school carbon fiber hood. Its not like the vis hoods where it has a fiberglass skeleten and rounded edes. I would call it raw. It flexes and is extremely lightweight.
I dont know the going rates for used parts anymore. shoot me an offer and ill post up pics. Its been hanging on the wall in the garage for a few years
I dont know the going rates for used parts anymore. shoot me an offer and ill post up pics. Its been hanging on the wall in the garage for a few years
<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by crawlin »</TD></TR><TR><TD CLASS="quote">pm me a price</TD></TR></TABLE>
just did
just did
Thread
Thread Starter
Forum
Replies
Last Post
victoriasamantha
Mid-Atlantic (Sales)
2
May 2, 2006 03:40 PM
sleepyAWDkid
Honda / Acura
83
Aug 9, 2005 03:11 PM




