Hey guys well with all the trouble with sleeving an boreing the block an taking it out to put the aftermarket pistons, i was think about buying a seperate block so i wont have to end up with out a car for a while an sending it later to get it sleeved so i can later on when i have a lil more money and time put my je 11.5:1 pistons, but mean while i wanted to add my built head an add to it some Crower 3's....would i get good horsepower with this with stock block???? are they good enough for the compression im going to run later??/

 

 

jdm or usdm motor?

plenty of people have run them on stock blocks.

In the prelude forum there is a FAQ sticky. take a look through it. there is tons of stuff in it

 

its a jdm motor

 

you can also use a thinner head gasket to bump the compression a little bit