t3 turbo oil inlet not fitting
Thread Starter
Junior Member
Joined: Aug 2006
Posts: 674
Likes: 0
From: go pack go, wi
t3 turbo oil inlet not fitting
i have a garret GAR-TA0301 that i bought from http://www.spooledmotorsports....s.php
and i bought a stealthmode oil line kit for hondas but the inlet flange that came with the turbo is just a tad to big for the oil line inlet would it be easier to buy a new flange or find a fitting that fits and any websites that sell something like that would be nice
thx in advance
and i bought a stealthmode oil line kit for hondas but the inlet flange that came with the turbo is just a tad to big for the oil line inlet would it be easier to buy a new flange or find a fitting that fits and any websites that sell something like that would be nice
thx in advance
Joined: Jul 2004
Posts: 4,144
Likes: 0
From: Farmington, MN, USA
Re: t3 turbo oil inlet not fitting (kaohli_yang)
Sounds like you have an inlet flange with a -4 male on the end. My feedlines are -3. Chances are the oil inlet is threaded with 1/8 npt, which allows the fitting that came with your kit to screw right into the turbo. In this case, I would throw the inlet flange in the toolbox. Any other problems please PM me.
Thread
Thread Starter
Forum
Replies
Last Post
pjr710
Forced Induction
16
Aug 17, 2007 04:33 PM
