I am trying to get my cams back to zero before I head off to the dyno. My head was milled 15 thousandth's. I am using TODA cam gears ("VERNIER" timing degree system). So from everything I have found -0.5 and -0.5 should get me back to 0,0. Just need some expert confirmation.

I found my Japanese instructions. Does anyone have an English copy of the instructions?



Modified by OH_1fstgsr at 4:46 AM 7/7/2007

 

I found the English version on my old computer.

 

If you milled the head you should have to advance your cams.

 

advance them +1 on each side, putting your gears at +.5/+.5 should be fine..

 

what about the distributor? Also, my head and block have been resurfaced, taken off 0.02" should i advance both intake and exhaust 2 degrees?