how hard is it to make a gsr's intercooler piping work for an ls motor? i realize the throttle body position is the main difference. just looking to see if anyong had any experience with this.

-sam

 

just cut, add a bit of piping, and reweld...

it's about 8 inches of height difference that the GSR and LS has...

GSRs have a bend down to accommodate for the secondary butterfly setup of the intake manifold....

if the piping is drag3, which is chromed... you'll have a bit of problem...

anything else... it's pretty simple...

just cut, add piping if necessary, and reweld...

about 30 minutes of work

 

sounds good, its not a drag kit. ill have a muffler shop do it it sounds like.

 

Just take it to Sandlimo and have them modify it. I'm sure a 20 dollar bill will help. Later Allen