Intercooler u bend for hot side.

Reply Subscribe

Thread Tools

Search this Thread

Nov 15, 2006 | 05:28 PM

EFvtec Yo!

Thread Starter

Honda-Tech Member

Joined: May 2005

Posts: 703

Likes: 0

From: Columbus, ga

Intercooler u bend for hot side.

I need to purchase a u bend comming off of the hot side of my intercooler. I found one on ebay and it has a 4 inch radius. Is that radius big enough?
This is the one I am talking about. I was gonna buy this one with the extra bend on it and just cut it off where it meets up to the piping coming off of my compressor. http://cgi.ebay.com/ebaymotors...photo

Nov 15, 2006 | 05:52 PM

EFvtec Yo!

Thread Starter

Honda-Tech Member

Joined: May 2005

Posts: 703

Likes: 0

From: Columbus, ga

anyone running a u bend like this?

Nov 16, 2006 | 05:51 PM

turbo_ls_69

Honda-Tech Member

Joined: Sep 2006

Posts: 378

Likes: 0

it should be big enough, but if its not you can cut it so its 2 90 degrees and put a peice of i/c piping in between the 2 90 bends to make it wider

Nov 16, 2006 | 06:47 PM

Schister66

Man U FTW

Joined: Sep 2005

Posts: 11,973

Likes: 2

From: Phoenix, AZ

Re: (EFvtec Yo!)

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote »</TD></TR><TR><TD CLASS="quote">anyone running a u bend like this? </TD></TR></TABLE>

that pipe is meant to be cut....the bend radius should clear, but i'm not quite sure because i dont remember the radius on my piping....

2000th post!