So I did my H22 swap and used my h23 distrubuter and coil on the h22, I have no tachometer, runs and idles great but no tach.... any ideas of what to do.

Modified by slammed95lude at 12:55 PM 9/10/2006


Modified by slammed95lude at 1:39 PM 9/10/2006

 

Also I am throwing the following codes

- 12 EGR
- 6 ECT....no cooling fan comes on
- 22 V-tec pressure switch
- 1 HO2S
- Oil light was on and flashing as well but that was because the single wire came out to the sensor which I think threw the v-tec pressure switch code

i pulled apart my ecu last nightt and found some dirt andsome oil on the outer cover and inside on the cover.... I cleaned it put it back in and am now running it, it is only flashing code 1. So should I drive it againt o see if a code pulls? Or will it pull at idle

 

Also I switched out the Temp sensor with a new one and no code yet.