i had a code that read out 24 on my 94 ls ecu... i figured it might be my tps sensor... what could it be... is it tps or is it another???

any comment that will be helpful will be greatful

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote &raquo;</TD></TR><TR><TD CLASS="quote">1 O2A - Oxygen sensor #1
2 O2B - Oxygen sensor #2
3 MAP - manifold absolute pressure sensor
4 CKP - crank position sensor
5 MAP - manifold absolute pressure sensor
6 ECT - water temperature sensor
7 TPS - throttle position sensor
8 TDC - top dead centre sensor
9 CYP - cylinder sensor
10 IAT - intake air temperature sensor
12 EGR - exhaust gas recirculation lift valve
13 BARO - atmospheric pressure sensor
14 IAC (EACV) - idle air control valve
15 Ignition output signal
16 Fuel injectors
17 VSS - speed sensor
19 Automatic transmission lockup control valve
20 Electrical load detector
21 VTEC spool solenoid valve
22 VTEC pressure valve
23 Knock sensor
30 Automatic transmission A signal
31 Automatic transmission B signal
36 traction control found on JDM ecu's
41 Primary oxygen sensor heater
43 Fuel supply system
45 Fuel system too rich or lean
48 LAF - lean air fuel sensor
54 CKF - crank fluctuation sensor
58 TDC sensor #2
61 Primary oxygen sensor
63 Secondary oxygen sensor
65 Secondary oxygen sensor heater
71 random misfire cylinder 1
72 random misfire cylinder 2
73 random misfire cylinder 3
74 random misfire cylinder 4
80 Exhaust Gas Recirculation insufficient flow detected
86 ECT Sensor (Engine Coolant Temperature) circuit range / performance problem
90 Evaporative Emission Control System leak detected in the fuel tank area
91 Fuel Tank Pressure Sensor low input
92 Evaporative Emission Control System insufficient purge flow</TD></TR></TABLE>

i dont see a code 24... re-check it.

 

You sure you're not getting two seperate codes? A 20 and a 4 perhaps? Makes sense if you look at list supplied above.

 

ill go check and get back to you guys

 

well i checked it again and its reading
10 IAT - intake air temperature sensor. how do i fix that??

94sib20

 

Just going out on a limb here, but try to replace the IAT?

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by IslandSi &raquo;</TD></TR><TR><TD CLASS="quote">Just going out on a limb here, but try to replace the IAT? </TD></TR></TABLE>

Or plug it in..lol

 

Codes I need fixin!sorry I got to try to post cuz I can't post till 15 days and i need help NOW DAMN IT!CODE 4,7,9,14,4 and 9 deals with sensors on the distributor,7 and 14 on the throttle f'ing body,I got a little jdm d15b,I changed the exhaust manifold to a z6,any advise?I don't want to give my hard earned money to some shop when I can fix it myself,Get a new distributor?new wire harness?SHARE YOUR THREAD DAMNIT!eg6

 

My 2000 honda civic is throwing a code, and it says that its missfiring on 1,2,3,4 but it seems to be running fine, what should i do??