I need some help with finding information on this topic, I heard that you have to have the rods trimmed or something, I saw a pic of it before but I can't find the site with that picture and information. An information on this topic would be greatly appreciated. And is this a job that could be done out of my garage??


Thanx..

 

Here is the pic http://tiiite.b16a.com/Specs/B16%2B17rodmod_1.jpg

 

you will need a machine shop to modify the rod and press the wrist pins out and in. you can install them in your garage if you know what you are doing.

 

that's the picture. Thanx..

What else should I consider when doing this swap??

And what rings could be used with these pistons? Do they have to be the CTR ones?

Thanx again

 

you can use itr rings, same part number.