I have a LSVTEC hatch and with a gsr head. My car didn't come with the timing belt covers. Would I just go on getting a LS bottom cover with a gsr or b16 top cover? For those who did it, did it match up fine?

 

When I installed my timing belt covers all three pieces were from a 99 GSR motor (even the lower cover) There was however cutting involved on the back cover to get it to line up flush and not rub against the timing belt. It took some time, but it wasn't too hard to do. Just take a good look at what is in the way and trim the cover accordingly. Good luck.

 

I'm using the ls bottom covers and the b16 top covers with a b16 head. With my set up I had to do a bit of cutting aswell but it was easy to make it fit.

 

why use any cover???

 

so you can adjust base timing. and check cam timing. btw i hope that was sarcasm

 

yes it was...but dont people only use the bottom one...when i see most motor setups there not a top cover

 

yeah a lot do to adjust cam timing. or just show off there bling bling cam gears. glad you dident take my comment the wrong way

 

haha neva bro