Question....i'm peicing together a custom exhaust but i want to know where yon can get an exhaust tip thats like the Buddy club spec 2.

eveything i see is slant cut??


I was just going to run stainless pipe with no tip.... but was interested in a spec2 type tip if i could fine one, but i've had no luck

any ideas?

 

get a normal piece of pipe and polish it

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by JDM EJ1 95 &raquo;</TD></TR><TR><TD CLASS="quote">get a normal piece of pipe and polish it</TD></TR></TABLE>

 

that was my plan...

 

mixwell

 

the actual axle-back piping is just slanted....giving you the impression the tip of the pipe is slant-cut




like everyone said....

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by JDM EJ1 95 &raquo;</TD></TR><TR><TD CLASS="quote">get a normal piece of pipe and polish it</TD></TR></TABLE>

 

Put a section of pipe 3 inch in diameter on there and polish it. Same damn thing.

 

yup! like everyone else said... fortuneatly i have a specII so i'm good! good luck, post pics when your done! i wanna see.

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by JDM EJ1 95 &raquo;</TD></TR><TR><TD CLASS="quote">get a normal piece of pipe and polish it</TD></TR></TABLE>

that's seriously what it is..

 

well it has somewhat of a resonator

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by carbing’ed &raquo;</TD></TR><TR><TD CLASS="quote">well it has somewhat of a resonator </TD></TR></TABLE>

So, thats what they're calling that little section of swollen piping...