I recently rebuilt my t3 42/48. But I never was able to rotate the center housing. Is there a way to break it loose? Every bolt except the two bitch bolts are out and the bitch bolts are loosened. I sprayed some wd40 but didn't go overboard. I was wacking the hell out of it, but I don't want to wack it too hard and throw it out of balance.

So any ideas. I need to figure this out so I don't blow the seals....again.

 

 

Let that thing soak with a generous amount of PB Blaster. If it still won't budge, you're gonna need some heat.

Sonny

 

Thanks, I'll try.

 

ya I'd spray it with some PB and just let it chill for a bit. Should break it loose.