TurboXS MBC question
Thread Starter
Honda-Tech Member
Joined: Nov 2001
Posts: 1,213
Likes: 0
From: TheNine2Five, Ca, USA
TurboXS MBC question
Is there a BIG difference between the Standard boost controller and the High Performance boost controller? I'm only going to boost a max of 10psi. TIA
Junior Member
Joined: Jun 2001
Posts: 907
Likes: 0
From: Zavodovski Island,, Antarctica
Re: TurboXS MBC question (integracon)
i believe the high proformance will allow you to boost higher - I think the cut off on the standard is like 15-17psi
you should be fine with the standard at 10psi
you should be fine with the standard at 10psi
Honda-Tech Member
Joined: Aug 2000
Posts: 4,232
Likes: 1
From: Alabaster, Al, USA
Re: TurboXS MBC question (integracon)
there is a huge difference.the high perf controller will allow you to build full boost until you reach your set boost pressure.it will spool much faster.
Thread Starter
Honda-Tech Member
Joined: Nov 2001
Posts: 1,213
Likes: 0
From: TheNine2Five, Ca, USA
Re: TurboXS MBC question (integracon)
Well I got it. Gotta say it does increase boost repsonse. I picked it up for $100 BRAND NEW shipped, not a bad deal. Also, I mounted it with my TIAL and ran into NO problems, like other members were having with this combo. Oh yeah, is heat a concern when dealing with the TurboXS? I wouldn't think so, cause everything is manual(Ball/Spring mechanism) I have it mounted just off the VTEC solenoid bracket.
Thread
Thread Starter
Forum
Replies
Last Post
