i have a 95 accord wit a jdm h22a, and the egr line is not connected, but the valve or the lil thingy is there, so anyone noe how to connect the wire together? any diagram or something? thanks alot

 

i thoguht if you had obd1 you dont have to worry about the egr? its not giving you a cel or anything right?

 

i got obdI and it throwin me with that code, it juss annoyin to see the engine check light on thats all, im plannin to get p28ecu but dunno if i can juss bypass the secondary butterfly or have to change the intake manifold

 

obd1 should not give you a cel. if your going p28 you will not be able to use your secondaries so either remove them or get the edelbrock or skunk2 im. there should be an electrical connector right there that sends a signal to the egr to control the lift valve inside of it. Just connect the connectors. don't know what else to tell ya

 

My OBD1 P13 gives a CEL for EGR.

Anyone know if changing to a P28 would be best mated with a different manifold (one w/o butterflies)? I want to get rid of my EGR too...

 

if your egr is nto hooked up it will give a code 12 on obd1.

and usually you jsut plug the wiring side lug into the egr lift sensor....usually that is
do you have a sqaure or round plug on the harness side?