Does anyone on this forum happen to own a GReddy or Edelbrock bolt on turbo kits?? if so do you happen to know the piping measurments from the intake manifold-fmic-turbo?? I need to make my charge pipes and need to start ordering the exact mandrel bends that i will be needing. all i know to my knowledge that pipe sizes that are available are 45, 90, and 180 degree mandrel bend pipes offered from http://www.jcwhitney.com. help is greatly appreciated.

 

1 90degree from the TB, 45 degree to angle to the hole, straight section, 45 degree down into the hole, another 45 to level off and a 90 into the IC.

2 90 degree bends
3 45 degree bends

Ordered them from Kteller.com cause his prices, service and goods are mega tiiite.