need some help.....valve job
Thread Starter
Joined: Aug 2004
Posts: 398
Likes: 0
From: WESTside
need some help.....valve job
ok guys this is my questions my set up is a 98 spec jdm type r motor...... i finally in the process of gettin my itbs and gettin ready to drop in all my ****.....
the set up is jun 3 cams, springs and retainers and itb's so my question is would i be better of getting a 3 or 5 angle job done? and should i get the head p&P? or could u do one of the 2 and not both?
the set up is jun 3 cams, springs and retainers and itb's so my question is would i be better of getting a 3 or 5 angle job done? and should i get the head p&P? or could u do one of the 2 and not both?
Thread
Thread Starter
Forum
Replies
Last Post
gakkuken
All Motor / Naturally Aspirated
1
May 8, 2005 02:40 PM