What's up guys so I've run into a couple problems with my motor mounts, the driver side mount on the engine has two bolts that are closer then my motor mounts that I ordered so essentially the driver side doesn't fit but I haven't tried the others is this because my engine possibly came out of the SIR CH9 instead of the 97-01 prelude? I had gotten this engine from JDM Depot in New Jersey but I can't tell which model car it came out of can anyone give me tips on where to look to know? Here's some pictures if it helps

 

For an h23a you have to use the drivers side mount off of an h22 or h23a1 for it to work

 

So all of my other motor mounts should be fine to put in? I just need the drivers side mount from a H22? And just one other thing, the motor I have is from Japan it's the SIR CH9 Accord engine. Does that still matter or no?

 

You need a driver's side H22 Engine Bracket... the part that bolts in inside the timing covers. This will work with the mount kit that you have pictured.

 

Make sure you also use the rear mount from a 5 speed, not an auto.