FS: CTR pistons fitted on LS rods with ARP
#1
Honda-Tech Member
Thread Starter
Join Date: Sep 2004
Location: Some where in, WA, USA
Posts: 1,610
Likes: 0
Received 1 Like
on
1 Post
FS: CTR pistons fitted on LS rods with ARP
Well I just took my block apart and I am selling my shotpeened LS rods with ARP rod bolts that are fitted to hold .25 over sized CTR pistons. I'm pretty sure the rings are bad. But im no expert. I will most likely have pictures of them tomorrow. I dont want to part it out. 200 shipped US. Thanks.
Modified by jakscivic at 9:45 PM 10/12/2005
Modified by jakscivic at 8:35 AM 10/21/2005
Modified by jakscivic at 9:45 PM 10/12/2005
Modified by jakscivic at 8:35 AM 10/21/2005
#5
Honda-Tech Member
Thread Starter
Join Date: Sep 2004
Location: Some where in, WA, USA
Posts: 1,610
Likes: 0
Received 1 Like
on
1 Post
This is the top of one piston. That is what about all four look like. I cleaned all the build up off the top pretty well. They look pretty new.
And here is a picture of all four of them. They come with bearings that looked pretty good to me. I used my finger nail to see if i could feel any roughness but it felt smooth. The piston rings look good to me, but Im not an expert. I just bought the block and the pistons and rods were only used for a couple thousand miles at most. The rods were also shotpeened.
Modified by jakscivic at 12:16 AM 10/22/2005
And here is a picture of all four of them. They come with bearings that looked pretty good to me. I used my finger nail to see if i could feel any roughness but it felt smooth. The piston rings look good to me, but Im not an expert. I just bought the block and the pistons and rods were only used for a couple thousand miles at most. The rods were also shotpeened.
Modified by jakscivic at 12:16 AM 10/22/2005